A coordinate system consists of datum and a projection. A datum is a system for applying a grid to the surface of the Earth using a reference or measurements. There are many different ways to place this grid on the earth, which formulate all the different types of datums. A map projection uses the datum as a point of reference to represent a spherical or curved surface on a flat plane.
There are a few types of coordinate systems, but commonly utilized are Geographic coordinate systems and Projected coordinate systems. Geographic coordinate systems are based on a spheroid and use angular units of measure (degrees). A Projected coordinate system is based on a spheroid projected onto a flat 2D surface and utilize linear units (meters, feet..ect.) Projected coordinate systems tend to be more commonly used (State planes, UTM, etc.).
Below are Nearmap's coordinate system specifications:
*** Please note the spatial accuracy of Nearmap imagery may be at a lower quality when using projections not listed in this document.
- EPSG:4326 - WGS 84 / Geodetic
- EPSG:3785 - aka EPSG:3857 - WGS 84 / World Mercator
- EPSG:4283 - GDA 94 / Geodetic
- MGA zones 49 to 56
- EPSG:28349 to EPSG:28356 - GDA 94 / MGA zone #
- SR-ORG:7400 Perth Coastal Grid 1994
- EPSG:3107 GDA94 / SA Lambert
NAD83 realization is "NAD83(2011) 2010.0 epoch"
- EPSG:4269 - NAD 83 / Geodetic
- NAD83 / UTM zones 9 to 18
- EPSG:26909 to EPSG:26918 - NAD83 \ UTM zone #
- EPSG:3310 - NAD 83 / California Teale Albers
****Use NAD83 / UTM Zones when using state plane systems. See UTM Zone chart below:
Proj4 grid file is for ITRF 2008 datum Epoch 2017.0 to NZGD2000 datum
- EPSG:4167 - NZGD2000 / Geodetic
- EPSG:3851 - New Zealand Continental Shelf Lambert Conformal 2000 (NZCS2000)
- EPSG:2193 - NZGD2000 / New Zealand Transverse Mercator 2000
- NZGD2000 / UTM zone
- EPSG:2133 - NZGD2000 / UTM zone 58S
- EPSG:2134 - NZGD2000 / UTM zone 59S
- EPSG:2135 - NZGD2000 / UTM zone 60S